Flash Magic Forum

In-System Programming Support => ARM Cortex => Topic started by: javiergonzalezb on March 27, 2020, 01:06:30 am

Title: Program NXP board LPCXpresso54628 using LPC_LINK2
Post by: javiergonzalezb on March 27, 2020, 01:06:30 am
Hello:
I'm trying to  program the LPCXpresso54628  with Flash Magic Software.
The first Time I could to program the board.
But, the next time when I wanted to program again, Flash Magic show error:

Operation failed. Failed to connect. Try disconnecting and reconnecting the board. Make sure the board appeart in the devices manager.
Title: Re: Program NXP board LPCXpresso54628 using LPC_LINK2
Post by: Andy Ayre on March 27, 2020, 08:55:03 am
Is the board still shown in the drop down list in section one?

Did you program it with firmware that disabled SWD? If yes then you won't be able to reprogram it again.

Andy