Messages

I have a problem more or less than you.

But i have another dude more.

After that I call the notouch(), Must i do a reset of the device?, or is sufficient only execut the funciont (notouch)

What do you think?

I have a circuit that creates this signal, but the devices don't go into the ISP mode, when i send this signal to PIN (6) of Reset, the device don't do anything.

Can it be because the signal is wrong?

If I do the correct signal, and send this signal to the pin, the devices go into ISP mode??

In this moment, I have my design with P89LPC935, and other board that create the RST signal also design for me.

What do you recomend me?

Hello,

I have finished one design, and I have a dude.


What is the best metode for going into thr ISP mode for P89LPC936, or P89LPC935?

I know what there are in the datasheet, the three pulses for RST. but i have read about notouch, and i don't know what is the best.

How do i use the three pulses(RST)?¿? I don't have any kit for programing, only have my board and the computer.

I need do more tests and i need program the uC more times.