Messages

 Dear Andrew,
                       I just checked the RST pin. I kept one 47K resistor across RST pin and ground .In previous ckt only a capacitor was there but resistor is not there, still it is working for P89c51RD2BA.Now it is working. The reason for this is, it is not resetting properly .I placed 47K and observed the  fall time as750 ms. Now it is working properly.
                    Thanks a lot for your response .

 Warm Regards,
 McNally.

Dear Anderw,
                       THankQ very much for the fast responce.Both are pin compatible .Yes i am selecting 669 as  the device place.I kept RD2 in the PLCC socket and PSEN is connected to GND.In flash magic in Tools menu there is Terminal sub menu ,I opened it and COM port and Baud rate is set ,and Pressed OK button,power is ON.

1.What ever i typed in Input box is appear in the Out put box.

2.After that I read Device signature from the ISP menu.It is comming correctly,Manufacturere ID as 15,Device ID 1 as 0xC2,Device ID 2 as 0x82.

3.I read Boot vetor and Status Byte.Boot vetor as 0xFC and status byte as 0x00 those are also comming correctly for RD2.
                             
                  After that i kept 669 ,i am not getting any thing.

Warm Regards,
McNally.

Dear Andrew Ayre ,
                                ThankQ for the suggestion you have made.I did that.I am using 11.0592 crystal in the previous board and 89C51RD2BA was working fine with that. Simply i changed the controller P89C669FA.I could not download any thing into it.What could be the problem??Should I do any thing other than this.I did all the debugging procedure what it has mentioned in the http://www.esacademy.com/software/flashmagic/appnotes/ISPProblemsAppNote.pdf site.I am getting reponce for the c51RD2 but for 89C669 i am not getting anything. Hope you will suggest .

Warm Regards,
McNally.

Hi,
         I am using P89C51RD2 which is having code memory of 64K (on chip).Can I use falsh Magic if my code size exceeds 64K for programming external flash memory??.

Regards,

McNally.