Messages

Thanks for the info. I had a look at the FDI dongle from Future Designs. Just a question:
This dongle refer to connections to the PCL and PDA pins and P0.5 and P0.4 respectively. I assume these are the same as the SCL ans SDA on the LPC915 device (Pin 7 and 6), OR must P0.5 and P0.4 (Pin 11 and 12) be used on the LPC915.

Am I correct to say that a new LPC915 can only be programmed using a MCB900 PCB? Is there any other way to program the device?

Thanks

Sorry, I selected the wrong device by accident. Thanks

I have downloaded the latest Flash Magic software (Ver. 3.40.177) and now I am getting the device signature error when I am trying to program a previously programmed P89C51RB2HBA device. What should the manufacturers and device signatures be? I am getting the following: Manufacturers ID = 0x15, Device ID1 = 0xC2 and Device ID2 = 0x8B.

I started a new project using the 89LPC915. Does Flash Magic support this device by using the TXD and RXD lines and the break condition to start the bootloader? If not what is the alternative method.