Hello Everyone,
I have started to work on P89V51RD2. To burn hex , I am using Flash Magic 3.71.245 .
I am following the steps given below:
1)Settings in P89V51RD2:
COM PORT: COM2 (I hve only this port)
Baud Rate: 9600
Device: P89V51RD2
Interface: None (ISP)
2)Option>Advanced option> Hardware Configuration> unchacked "Use DTR to control RST" > unchecked "Assert DTR and RTS while COM port open"
3)Pressing switches connected at Pin 9(RST) and Pin29(PSEN) .
4) Browse the .hex file
5) select "Start"
6) after getting Messege : "Reset the device into ISP mode", Releasing switch at Pin 9 (RST)
7)Releasing switch at Pin 29 (PSEN)
After some time , I get Messege: "Erasing Device... "
9) After a long time, I get Messege: "Programming.."
10) After a few second, I get Messege: "Unable to communicate (transmit / receive)"
Thus, currently It is not working. Please any one suggest me some correct way to get proper result.
Please, reply soon.
Thank you
I have started to work on P89V51RD2. To burn hex , I am using Flash Magic 3.71.245 .
I am following the steps given below:
1)Settings in P89V51RD2:
COM PORT: COM2 (I hve only this port)
Baud Rate: 9600
Device: P89V51RD2
Interface: None (ISP)
2)Option>Advanced option> Hardware Configuration> unchacked "Use DTR to control RST" > unchecked "Assert DTR and RTS while COM port open"
3)Pressing switches connected at Pin 9(RST) and Pin29(PSEN) .
4) Browse the .hex file
5) select "Start"
6) after getting Messege : "Reset the device into ISP mode", Releasing switch at Pin 9 (RST)
7)Releasing switch at Pin 29 (PSEN)
After some time , I get Messege: "Erasing Device... " 9) After a long time, I get Messege: "Programming.."
10) After a few second, I get Messege: "Unable to communicate (transmit / receive)"
Thus, currently It is not working. Please any one suggest me some correct way to get proper result.
Please, reply soon.
Thank you