Thank you for your answer but now it's ok !
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
P89V51Rx2/P89LV51Rx2 / Problem for programming P89V51RD2
February 08, 2007, 09:28:13 AM
Hello everyone,
I've got a problem. I'm working on a new board (with P89V51RD2) based on a older validated board (with P89C51RD2).
To program the old board, I used Flash Magic directly (I did not have to reset the P89C51RD2).
Now I want to program the P89V51RD2 on my new board. When I try to read the device signature, I've got a message : "Reset the device into ISP mode now". What is the way to follow ?
Another question (I'm just beginning in programming such micros) : I've got a code working on P89C51RD2 ; what must I do (excepting choosing the rigth device to get the .hex file) to obtain a .hex file working on P89V51RD2 ?
Thank you !
Jess
I've got a problem. I'm working on a new board (with P89V51RD2) based on a older validated board (with P89C51RD2).
To program the old board, I used Flash Magic directly (I did not have to reset the P89C51RD2).
Now I want to program the P89V51RD2 on my new board. When I try to read the device signature, I've got a message : "Reset the device into ISP mode now". What is the way to follow ?
Another question (I'm just beginning in programming such micros) : I've got a code working on P89C51RD2 ; what must I do (excepting choosing the rigth device to get the .hex file) to obtain a .hex file working on P89V51RD2 ?
Thank you !
Jess
Pages1