Hello,
Have a NGX BlueBoard 1768-H and I am looking to program the LPC1768 using FlashMagic. Trying to determine what UART signals I need to provide from my PC. I'm assuming at least TX and RX but are there any others? I notice my board has a connector that provides a signal to put the 1768 into ISP mode-does FlashMagic use one of the RS-232 lines to drive this signal? Is the TX on the 1768 an input or an output? (I understand I need to do level conversion on the RS-232 signals)
Thanks!
Have a NGX BlueBoard 1768-H and I am looking to program the LPC1768 using FlashMagic. Trying to determine what UART signals I need to provide from my PC. I'm assuming at least TX and RX but are there any others? I notice my board has a connector that provides a signal to put the 1768 into ISP mode-does FlashMagic use one of the RS-232 lines to drive this signal? Is the TX on the 1768 an input or an output? (I understand I need to do level conversion on the RS-232 signals)
Thanks!