Messages

Hi,
I have recently bought a MCB900 (vers.4). I never used the ISP
programming until now.
I succeeded to program PLCC28 microcontrollers, by plugging the LPC
into PLCC28 socket.
I have tryed to program other LPCs with ISP capabilities (having 20
pins), in TSSOP or DIL case.
I removed the PLCC28 microcontroller from MCB900 board;
I connected the P89LPC932's ISP lines of the MCB900 board, through a 5
wires cable, to a P89LPC920 in TSSOP20 case, from an external board
(P89LPC920 was soldered on the board):
(VDD,GND,RESET,RXD,and TXD) from the P89LPC932 socket to
(VDD,GND,RESET,RXD,and TXD) from the P89LPC920 board..
I respected the jumpers' positions Run-off, RST-on on MCB900 board, but
I couldn't program with Flash Magic the microcontroller from this new
board.
Could anybody help me...?
Thank you very much!

Doru