You are right, I don't know why, but I still looked up in the oldest Version of my Datasheet...
Thank You
Thank You
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
P89V51Rx2/P89LV51Rx2 / IAP commands P89V51RD2
June 18, 2007, 06:05:53 PM
Hello,
I have got a question, is there any command in IAP mode available for eraseing single Data Bytes or sectors? In the Data sheet is just one command for eraseing the whole Block 0. Had there been any updates?
Does anyone has an updated Firmware, that is able to erase single Databytes or sectors?
Thanks in advance.
Rudi
I have got a question, is there any command in IAP mode available for eraseing single Data Bytes or sectors? In the Data sheet is just one command for eraseing the whole Block 0. Had there been any updates?
Does anyone has an updated Firmware, that is able to erase single Databytes or sectors?
Thanks in advance.
Rudi
Pages1