Messages

Thanks for reply, I can see the progress but not success.

I uncheck the option: Use DTR to control the RST. And now it is showing the message "Reset the device in ISP mode". Now I am turning the power ON here ( and also tried to reset while power ON and OFF both). But it is just hanging over there and not doing anything. I confirm the COM port number, reduced the baudrate. I can't figure out, what can be the problem.

Thanks for reply,

In Interface drop down list, I have selected "None (ISP)". And from main menu, ISP tab(or what ever we say), I select blank check etc.
Is there any thing else I require to do?

Hi,
I got OLED demo kit from OSRAM Pictiva. Which has P89LV51RD2BBC. I have downloaded the flashmagic from this website. And trying to program but it is giving me the following error.
"Unable to connect at the specified baudrate. Start reducing the baudrate again. Reset the hardware into ISP mode".

I have selected baudrate to 2400. And it is giving the same error when I do:
ISP->Reset
ISP->Device Signature
ISP->Blank Check.

I am using COM port 1. With interface: (None)ISP. Erased all flash is checked. Verify after programming is checked.

I can't figure out what can be problem. We got ready made kit from OSRAM pictiva. Can there be problem in the hardware? What it can be? Please help.

Thanks,