It may well have a bootloader factory programmed into it, but looks like you might
have to search outside of the datasheet for info on that.
Data sheet talks about Serial Wire Debug (SWD) but not JTAG. Two pins for this,
SWDIO and SWCLK. Perhaps it's a derivative of JTAG, I don't know.
This device should be as simple as any to get started with, no doubt easier if you
use an off the shelf dev kit like one of these which seem cheap enough...
http://ics.nxp.com/lpcxpresso/~LPC1114/
I'm just barely getting started with ARM, going with an Olimex LPC-2378STK dev kit
I bought a couple of years ago but just switched on last week. I'm not even at
flashing an LED stage yet, there is quite a learning curve in the tool chain setup etc.
have to search outside of the datasheet for info on that.
Data sheet talks about Serial Wire Debug (SWD) but not JTAG. Two pins for this,
SWDIO and SWCLK. Perhaps it's a derivative of JTAG, I don't know.
This device should be as simple as any to get started with, no doubt easier if you
use an off the shelf dev kit like one of these which seem cheap enough...
http://ics.nxp.com/lpcxpresso/~LPC1114/
I'm just barely getting started with ARM, going with an Olimex LPC-2378STK dev kit
I bought a couple of years ago but just switched on last week. I'm not even at
flashing an LED stage yet, there is quite a learning curve in the tool chain setup etc.
