Understood. I have access to the reset button and if it's a matter of pressing return on the command line and then hitting the reset button (or vice-versa) then it should be possible to access ISP. So is there a device with similar memory mapping that I could use if I went through the aforementioned steps?
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
P89V51Rx2/P89LV51Rx2 / P89V51RD2 Command Line Programming?
May 07, 2006, 11:07:11 PM
Hi all,
I'm unable to get the FM ISP to work on the 89V51RD2 when using command line drive. Works fine through the GUI.
I'm sending:
FM com(1,9600) device(89V51RD2,6.000) erase(0,protectisp) hexfile(le2100_a.hex, nochecksums, nofill, protectisp) verify(le2100_a.hex, nochecksums)
To which the reply is:
ERROR: Invalid parameters for DEVICE directive: device(89V51RD2,6.000)
Any clues?
I'm unable to get the FM ISP to work on the 89V51RD2 when using command line drive. Works fine through the GUI.
I'm sending:
FM com(1,9600) device(89V51RD2,6.000) erase(0,protectisp) hexfile(le2100_a.hex, nochecksums, nofill, protectisp) verify(le2100_a.hex, nochecksums)
To which the reply is:
ERROR: Invalid parameters for DEVICE directive: device(89V51RD2,6.000)
Any clues?
Pages1