Hi Everyone,
Am new to this,Am using NXP LPC1765 controller,am doing insist programinng using flash magic. But i had a problem in that. After programming the controller is not booting(not going to user application mode). I have disabled the isp pin once i finished the programing. I have checked with Scope the Tx & Rx pins of the controller. the data is transfering. Both pins Tx & Rx are working fine. Kindly suggest me what will be the problem here? Will it be Software Issue or Hardware Issue??
Thanks in advance
Regards,
Samson
Am new to this,Am using NXP LPC1765 controller,am doing insist programinng using flash magic. But i had a problem in that. After programming the controller is not booting(not going to user application mode). I have disabled the isp pin once i finished the programing. I have checked with Scope the Tx & Rx pins of the controller. the data is transfering. Both pins Tx & Rx are working fine. Kindly suggest me what will be the problem here? Will it be Software Issue or Hardware Issue??
Thanks in advance
Regards,
Samson