Messages

Hi Andy,

I have another question regarding the starting address of application that download by Ethernet bootloader.

In normal condition (without the bootloader) I run my application and it work well.

But when I download it with Ethernet bootloader, it doesn't work no matter I changed the starting address from 0x0 to 0x2000

What other parameter should I change in my application so that I can work after downloaded by Ethernet bootloader.

The application I am using is the tiny webserver from Keil
You can find it here: http://www.keil.com/download/docs/295.asp

Thank you for your great support.

Thank you Andy,

It works fine 

Hi Andy,

Thanks for your help.

I am using crossover cable as your guide.
I have tried to compile the source code of Ethernet Bootloader for LPC23xx from Flash Magic bundle, but got the error as below

.\Obj\ethernet_bootloader.axf: error: L6031U: Could not open scatter description file .\Obj\ethernet_bootloader.sct: No such file or directory
Target not created

Could you please advise on this.
I have try with uVision4 and uVision3, still the same error

[http://forum.flashmagictool.com/index.php?topic=3790.0]

Hi Andy and every body,

I have problem with Ethernet Bootloader on LPC2366.
I have followed the instruction from here http://forum.flashmagictool.com/index.php?topic=3790.0
I use WireShark to capture the Frame send out from the Host when I use Flash Magic and I got the data as expected (which is ?<CR><LF>)

But the code on LPC2366 can't received the Frame send out from Flash Magic.

I have put the debug code to print out message thru UART when MAC_RXPRODUCEINDEX != MAC_RXCONSUMEINDEX

MAC_RXPRODUCEINDEX != MAC_RXCONSUMEINDEX
   print("UDP Frame\n");

So I wonder whether the Ethernet Bootloader code from NXP website is the latest one.
If you have done this before, could you please share with me the Ethernet Bootloader Code?

Thanks.