Hello Andy Ayre,
I'm trying to write a SPIFI memory of a board with LPC1830 using Flash Magic version 7.71 with External Memory option.
This board has a program in SPIFI and OTP is set to boot from SPIFI. It's work well.
It seems that the FM does not reset to load the External Memory driver.
I read the topic "Support device with off chip ROM? (LPC1830 with SPIFI)" and saw that this problem would be solved in Flash Magic version 7.21.
I just tried to load and run a teste program in RAM. The load works but then some times it runs the program that is already in SPIFI (must be a reset following the load, with high ISP).
If I do GO <RAM entry point, opt> does not run a program load (SPIFI program does not use the same RAM area).
I tried to use the FM.exec / DOS. Loading is OK but don't run neither two program.
These tests were done with a very simple program of 550 bytes and has been tested on the same board using the JTAG Debug.
Please can you help me?
Sorry for my bad english .
Ivar
I'm trying to write a SPIFI memory of a board with LPC1830 using Flash Magic version 7.71 with External Memory option.
This board has a program in SPIFI and OTP is set to boot from SPIFI. It's work well.
It seems that the FM does not reset to load the External Memory driver.
I read the topic "Support device with off chip ROM? (LPC1830 with SPIFI)" and saw that this problem would be solved in Flash Magic version 7.21.
I just tried to load and run a teste program in RAM. The load works but then some times it runs the program that is already in SPIFI (must be a reset following the load, with high ISP).
If I do GO <RAM entry point, opt> does not run a program load (SPIFI program does not use the same RAM area).
I tried to use the FM.exec / DOS. Loading is OK but don't run neither two program.
These tests were done with a very simple program of 550 bytes and has been tested on the same board using the JTAG Debug.
Please can you help me?
Sorry for my bad english .
Ivar