Messages

Thanks for update.

I downloaded the new Flashmagic. There is an improvement. Now I can read Chip ID and check blank status.
However, when I tried to program a hex file it did not work.

First it complained about the Chip signature not matched and it asked if I want to continue. I press ok to continue. Then it started to erase flash block 0. But it never passed.

I have attached the debug log file for your reference.

How I did see the device signature not matched? I have selected right CPU. LPC4357.

Thanks

The LPC4357 board is our custom board.
We are using LpcXpresso to program and debug it. But since recently we needed to program few tens of test boards and we decided to use flashmagic. However there is no luck. The SWD interface is working well with LpcXpesso. I am attaching the schematic that has SWIO interface connector.
I tried the crystal value of 12 and it is same.

I also have the same problem with LPC-Link2 trying to program LPC4357..
It complains about autobaud fail and LED on Link2 blinks.
I am selecting SWD over Link2...
Is there any solution yet?

I have attached degug log file.. if anybody need it