i have the same problem too, cant connect to flash magic.
I've tried to change the configuration of the external crystal using ISP/Device Config/Clock/Options choosing external high frequency clock but the error i received was "unable to connect at the specified baud rate, try reducing the baud rate, reset the hardware into ISP mode again". apparently, every setting we have changed results in this error message.
I've also tried to send the "U" command using the bootloader and the error message was "operation failed. (start bootrom command - no echo)
i also had nxp to check out my schematics and they mentioned that it is okie.
pls help
I've tried to change the configuration of the external crystal using ISP/Device Config/Clock/Options choosing external high frequency clock but the error i received was "unable to connect at the specified baud rate, try reducing the baud rate, reset the hardware into ISP mode again". apparently, every setting we have changed results in this error message.
I've also tried to send the "U" command using the bootloader and the error message was "operation failed. (start bootrom command - no echo)
i also had nxp to check out my schematics and they mentioned that it is okie.
pls help