Thanks fo the advice. Can I use the IAP Lite to write 0x01 to the status bit If so, what is the address of the status bit? (Sorry, I am new at this)
Thanks
Thanks
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Old Topics / How to send a LPC921 into ISP with USB?
July 15, 2004, 05:05:20 AM
I want to be able to send my LPC921 into ISP mode using a USB cable, but I do not want to add another micro to the board. Will just calling the the boot loader (by setting the Boot Status bit) when voltage is detected on the USB line work? Right now I plan an input pin on the LPC921 connected to the USB device. If there is a better way, please tell me. Thanks.
Brian
Brian
Pages1