I've got the same problem the thread author has. Philips Flash Utility doesn't work (Read Device ID doesnt work) and Flash Magic always says "Operation failed. (failed to autobaud - step1)" I use an Olimex LPC-H2294 Board. How can I check if its Rev.A or not?
The Board is connected to USB Port via the Olimex ARM-USB-OCD Adapter. USB-Serial Port is configured as COM3 which I have chosen in Flash Magic as well. I tried with the smallest Baud Rate, 2400. However, I cannot even read the device Signature. Which Interface do I have to choose in Step 1 then? Or should I connect the board to USB directly. In that case, my PC needs drivers for "USB<->Serial". Where can I find them?
Any other mistakes I could have done? In which position do I have to put the Switches and how must the Jumpers be placed?
Thank you.
The Board is connected to USB Port via the Olimex ARM-USB-OCD Adapter. USB-Serial Port is configured as COM3 which I have chosen in Flash Magic as well. I tried with the smallest Baud Rate, 2400. However, I cannot even read the device Signature. Which Interface do I have to choose in Step 1 then? Or should I connect the board to USB directly. In that case, my PC needs drivers for "USB<->Serial". Where can I find them?
Any other mistakes I could have done? In which position do I have to put the Switches and how must the Jumpers be placed?
Thank you.