We worked around the problem by implementing the bootloader protocol in a simple command line app using hidapi, which also lets me run it on MacOS and Linux. Seems to be working well.
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
ARM Cortex / LPC55S28 (USB, LPC5500) Operation failed
September 21, 2021, 06:47:09 AM
I connect my device via USB (directly, no UART involved), and try to write firmware data to the flash.
FlashMagic says: LPC55S28 (USB, LPC5500) Operation failed. (programming - failed to send data to the device)
Debug file attached.
Any ideas on what could be wrong? As far as I know it's a brand new chip, so there shouldn't be any locked areas and such. Reading signature works, blank check works, erasing works. It's only firmware download that doesn't work.
Also FLashMagic crashes a lot when using the USB interface, maybe that indicates that something in particular is wrong?
kind regards,
Mikael
FlashMagic says: LPC55S28 (USB, LPC5500) Operation failed. (programming - failed to send data to the device)
Debug file attached.
Any ideas on what could be wrong? As far as I know it's a brand new chip, so there shouldn't be any locked areas and such. Reading signature works, blank check works, erasing works. It's only firmware download that doesn't work.
Also FLashMagic crashes a lot when using the USB interface, maybe that indicates that something in particular is wrong?
kind regards,
Mikael
Pages1