Messages

Dear Sir,
            I have checked that data is comming out from USB-ICP-LPC2K to LPC2378 on its RXD(pin 142). but LPC2378 is not sending any data on TXD(pin 141). other thing that I have noted down, there is no change in Reset(pin 24) of LPC2378. but there is change comming on P2.10(pin 76), when I press start button.Note down I have not connected any external pull up resistance to any pin of LPC2378.

kindly help me to know what is problem and it can be resolved.

thanks and regards.

ifailed to program LPC2378 using USB-ICP-LPC2K and magic flash. i have done the following connections. flash magic always shows the step1 autobaud failed.


         USB-ICP-LPC2K                   LPC2378

pin     1                                         3.3V

         2                                         Reset (pin 24)

         3                                         P2.10 (pin 76)

         4                                         GND

         5                                         RXD0 (pin 142)

         6                                         TXD0 (pin 141)


i have done the following flash magic settings

COM port-COM7
Baud rate-9600
Device-LPC2378
interface-FDI USB-ICP-LPC2K
oscilliator-11.0592

flash magic always shows the step1 autobaud failed.
why does this error come?


kindly help to program the flash of LPC2378.


Thanks and Regards