Trying to program 2378 on mcb2300 board using flashmagic serial port.
As far as I can tell, the board is setup to program using serial port. The jumper settings are as follows:
J10 - ISP is IN (ON)
J13 - ETM is OUT (OFF)
When you try to program, it fails to autobaud - with the message - autobaud failed - step 1
If I try to read the device signature, it is the same response.
I have seen some posts on this but no clear answers as to what is wrong.
I would think that this should be the simplest thing to do i.e. program the device using serial port with a utility that is designed to do this?
Any suggestions?
Thanks
As far as I can tell, the board is setup to program using serial port. The jumper settings are as follows:
J10 - ISP is IN (ON)
J13 - ETM is OUT (OFF)
When you try to program, it fails to autobaud - with the message - autobaud failed - step 1
If I try to read the device signature, it is the same response.
I have seen some posts on this but no clear answers as to what is wrong.
I would think that this should be the simplest thing to do i.e. program the device using serial port with a utility that is designed to do this?
Any suggestions?
Thanks