Hey everybody!
I read thru the FMF but couldn´t find a topic that fits my problem ... and here it is:
I have build several different Circuit Boards with the LPC2378 as MCU. They all work well.
After beeing several times programmed, there seems to be a failure in the serial communication. Let me explain exactly:
1st I use a DIP-Switch to get the ISP-Pin grounded(P2.10)
2nd I turn the power on
3rd I can see that the LPC2378 is in ISP-Mode cause the LEDs used in my design are normaly turned off, and now they are all on
4th I try to program the LPC2378 (like I did with exact the same device several times before [and in that cases with sucess]) but it could not connect.
5th Now I turn the power of, get the device out of the ISP-Mode(by using the mentioned DIP-Switch) and turn it on again, to see if there is any damage on the device ... But everytime the old firmeware is still running perfect and there seems to be no damage to the device
The only thing that doesn´t work anymore seems to be the serial port on the LPC2378.
I am sure that there is everything fine with the hardware, for it works several times (e.g. 10 times) and then the above mentioned happens.
Is there any possibility that I have to set a flag while I to program the device, that I have overseen??
Could anyone give me any hint???
If you need more (and perhaps exacter) infos please let me know.
Thanks in advance!!!!
I read thru the FMF but couldn´t find a topic that fits my problem ... and here it is:
I have build several different Circuit Boards with the LPC2378 as MCU. They all work well.
After beeing several times programmed, there seems to be a failure in the serial communication. Let me explain exactly:
1st I use a DIP-Switch to get the ISP-Pin grounded(P2.10)
2nd I turn the power on
3rd I can see that the LPC2378 is in ISP-Mode cause the LEDs used in my design are normaly turned off, and now they are all on
4th I try to program the LPC2378 (like I did with exact the same device several times before [and in that cases with sucess]) but it could not connect.
5th Now I turn the power of, get the device out of the ISP-Mode(by using the mentioned DIP-Switch) and turn it on again, to see if there is any damage on the device ... But everytime the old firmeware is still running perfect and there seems to be no damage to the device
The only thing that doesn´t work anymore seems to be the serial port on the LPC2378.
I am sure that there is everything fine with the hardware, for it works several times (e.g. 10 times) and then the above mentioned happens.
Is there any possibility that I have to set a flag while I to program the device, that I have overseen??
Could anyone give me any hint???
If you need more (and perhaps exacter) infos please let me know.
Thanks in advance!!!!