Messages

Thanks, I needed to "Erase all Flash+Code Rd Prot" to be able Flash.

Regards
Bent

When you go to ISP -> Read Security what does it say in the window? Flash Magic thinks that the CRP level is set to 2 or 3, stopping any writing to flash.

Andy

I'm trying to program a LPC2138FBD64/01 using Flash Magic v5.40.1801, but the programming fails. I can read the device id and security.

Manual start of boot loader mode. (P0.14 low while Reset goes high)
1) Read Device Signature -> ok
2) Read Security -> ok
3) Start flashing -> Operation Failed. (programming - failed to send data to the device)

LPC2138FBD64/01
Device ID: 0x0002FF25
Bootloader Ver. 2.12

COM port 1.
Baud Rate 115200
Interface None (ISP)
Oscillator (MHz): 14.7456

Hex File: C:\ProgramTest.hex

I have tried other Baud Rates without any luck.

Regards
Bent Nielsen