hello every one...
I am using a MSC 900 board to programming LPC935. I am using the COM port on my desktop the programming run always well!
If I used the usb2serial cable (UTM1925 USB-Multi-IO cable) on my laptop, reading device configuration runs well, also reprogramming device configuration runs well. After starting programming the status shows "Erase" and next "Programming" and than the flash magic shoes any reactions. After braking flash magic and restarting, the command "Reading device configuration" will quit with "Unable to communicate (in use) Ensure no other aplications are using COM port. Try raising or lowering baud rate. I must restart WINOWS that FlashMagic works again.
Every body has an idea?
Thanks
Helmuth
I am using a MSC 900 board to programming LPC935. I am using the COM port on my desktop the programming run always well!
If I used the usb2serial cable (UTM1925 USB-Multi-IO cable) on my laptop, reading device configuration runs well, also reprogramming device configuration runs well. After starting programming the status shows "Erase" and next "Programming" and than the flash magic shoes any reactions. After braking flash magic and restarting, the command "Reading device configuration" will quit with "Unable to communicate (in use) Ensure no other aplications are using COM port. Try raising or lowering baud rate. I must restart WINOWS that FlashMagic works again.
Every body has an idea?
Thanks
Helmuth