Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mform

#1
I am using an 89LPC935 in a new circuit and using Flash Magic. I try and clear the checkbox to enable the RESET pin (that is, I don't want to use RESET) in the device configuration. I get a message box saying that the device was re-programmed correctly, but when I read the Device Configuration again, the enable RESET box is still checked. I have used FM many times and this is puzzling. Does anyone have an idea on what is going on?

Thanks.

Mike