Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - canggou

#1
LPC2xxx / Re: LPC2103 command line problem
October 25, 2007, 02:03:18 AM
Thanks in advance for any help. Sincerely:)
#2
LPC2xxx / LPC2103 command line problem
October 25, 2007, 02:02:47 AM
First:My English is not so good

The problem is:
1. if you power on the LPC2103 then try to flash the AMR using command line within approximately 10 seconds
fm @a.txt
a.txt contents
COM(1, 9600)
DEVICE(LPC2103, 10.760000)
HARDWARE(BOOTEXEC, 50, 100)
HEXFILE(D:\a.hex, NOCHECKSUMS, NOFILL, PROTECTISP)
fm will succeed.
2. but if you power on the LPC2103 then try to flash the AMR using command line after approximately 10 seconds
fm @a.txt
a.txt contents
COM(1, 9600)
DEVICE(LPC2103, 10.760000)
HARDWARE(BOOTEXEC, 50, 100)
HEXFILE(D:\a.hex, NOCHECKSUMS, NOFILL, PROTECTISP)
it will failed with following msg:
connection failed:invalid command