1
General Discussion / Problems with command STARTBOOTLOADER (Command line)
« on: August 05, 2013, 10:35:22 am »
Hello,
I have tried to set the target device (LPC2106) into ISP mode with the STARTBOOTLOADER command (program version of FM.EXE is 7.51.3222). In my case it is a simple '!'
So I tried
I also tried to specify the COM port and the Device:
If I try to enter the ISP with a terminal program (HTerm) or even the "Start Bootloader"-Option in the GUI of Flash Magic it works fine.
Other command lines instructions are also working fine. e.g.: it was no problem to flash a hexfile with following instruction
During my experiments with the STARTBOOTLOADER command I tried the '&'-commands which are mentioned in the manual. Especially the &00 command (flush RX buffer). But none of the '&' command seem to work. I always get the error message, that the command 00 is unknown.
Are there some known issues with the STARTBOOTLOADER command or am I just using the wrong parameters?
Best regards
Rainer
I have tried to set the target device (LPC2106) into ISP mode with the STARTBOOTLOADER command (program version of FM.EXE is 7.51.3222). In my case it is a simple '!'
So I tried
Code: [Select]
FM STARTBOOTLOADER(9600, %21, NOCONTROL)
in the command line. But nothing happened - the FM-Tool isn't sending anything to target device (I monitor the serial traffic with a COM sniffer tool). I also tried to specify the COM port and the Device:
Code: [Select]
FM COM(2, 9600) DEVICE(LPC2106, 14.7456, 0) STARTBOOTLOADER(9600, %21, NOCONTROL)
The same result -> no reaction on the COM Signal to the target device. Also there was no error message in both cases.If I try to enter the ISP with a terminal program (HTerm) or even the "Start Bootloader"-Option in the GUI of Flash Magic it works fine.
Other command lines instructions are also working fine. e.g.: it was no problem to flash a hexfile with following instruction
Code: [Select]
FM COM(2, 9600) DEVICE(LPC2106, 14.7456, 0) ERASE(DEVICE, PROTECTISP) HEXFILE(Button.hex, CHECKSUMS, NOFILL, PROTECTISP)
During my experiments with the STARTBOOTLOADER command I tried the '&'-commands which are mentioned in the manual. Especially the &00 command (flush RX buffer). But none of the '&' command seem to work. I always get the error message, that the command 00 is unknown.
Are there some known issues with the STARTBOOTLOADER command or am I just using the wrong parameters?
Best regards
Rainer