Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - JulianCox

#1
LPC9xx/LPC9xxx / Re: LPC938 programming problem
March 10, 2014, 04:37:07 AM
NO!  Since this problem started it gets stuck every time - unless I first erase the chip.
#2
LPC9xx/LPC9xxx / LPC938 programming problem
March 06, 2014, 02:24:10 AM
I am using a USB-ICP dongle from FDI to program a LPC938.  I am developing new code on the target machine and all electrical loads on the chip are isolated for programming) After several successful attempts it suddenly failed. Specifically: - at address 0x0740 it hangs up, waits and then issues a "failed to communicate" error message. I then cancel, carry out an Erase operation and then try again to program the chip - which is always successful. If I then re-program the chip with the same code, it is also successful. This is not a disaster, but it is very annoying.