Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Shoda

#1
ARM Cortex / Re: I can not Verify in LPC810
December 18, 2014, 05:53:11 PM
Hi Andy,
I solved the problem using V8.62. In addition, LPC824 also work well.
Thank you for correspondence immediately.

Shoda
#2
ARM Cortex / Re: I can not Verify in LPC810
December 16, 2014, 10:29:02 AM
I was able to program, without verifying. And was able to execute correctly.

I'm sorry. LPC1114 is no problem. (I was wrong connection.)

Shoda
#3
ARM Cortex / Re: I can not Verify in LPC810
December 15, 2014, 11:01:11 PM
I will send again.

Shoda
#4
ARM Cortex / Re: I can not Verify in LPC810
December 12, 2014, 06:21:22 AM
Hi

I tried again.

1 both options enabled
     Same to the first question.

2 Send Line Feeds is enabled.
      Read Device Signature >> "Oparation Failed (reading signature)"
      Display Memory, Programming >> "Faild to read the device signature ....... using the wrong protocol ....... device unusable. Do you     want to continue? "  Then "Operation Failed"

3 Expect Line Feeds is enabled.
      Read Device Signature, Display Memory, Programming >> "Unable to commmunicate. (Transmit / receive) Ensure no other ........., Try raising ..... baud rate." 

4 both options disabled
      Read Device Signature, Display Memory, Programming >> "Unable to connect to ....... (failed to autobaud-step2) Reset the hardware into ISP mode again."

Baud rate change, ISP mode setting, it has been tried, such as com port change, the result is the same.

Shoda
#5
ARM Cortex / Re: I can not Verify in LPC810
December 12, 2014, 03:25:48 AM
Hi Andy.
Immediately answer Thank you.
"send Line Feed" or "expect Line Feed" the results were "Operational Failed (reading Signature)". It was the same result as until now If I enable both options.

Shoda
#6
ARM Cortex / I can not Verify in LPC810
December 11, 2014, 09:26:32 PM
It can be written in Flash Masic 8.61, but can not seem to read.

Read Device Signature >>> OK
Display Memory >>> "Unable communicate (transmit / receive)"

Hex File of writing can be, (the program to work without problems) but, long time to wait is error message appears in the Verify. >>> "Error Verifying. There is a difference in the Hex file value and the stored value. (Address 0x00000001)

I tried a combination of new chip , LPC1114, Win7, Win8.1, PL2303SA,  FT232RL it was the same result. However, in Flash Masic 7.66, I will work well.
Why. Please help me.
I'm sorry in poor English.