Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - relentless

Pages: [1]
1
ARM Cortex / Re: Show memory dialog fails on LPC4337
« on: September 08, 2015, 02:15:50 am »
Device itself programming is working - there's some problem with LPCXpresso production, as after switching to IAR sample project runs ok, while LPCXpresso seems to output some bad hex file.

2
ARM Cortex / Re: Show memory dialog fails on LPC4337
« on: September 08, 2015, 01:34:09 am »
Version is 9.31.3960 (yesterday updated from 9.30, but problem described is the same in 9.31)

Please see debug file attached.
First, I run programming with "Erase all flash" - works ok. Then programming with "erase paged used by flash" - got the error message as before.
And finally I opened "show memory" dialog - it did not reported error or AV, but shows some strange content

3
ARM Cortex / Show memory dialog fails on LPC4337
« on: September 07, 2015, 07:50:13 am »
Hi !

Tried your tool with LPC4337 and starter board from starterkit. Added several hardware modifications for the board, as UART0 pins are partially used with Ethernet, so needed to move boot to UART3. FlashMagic detects the controller, correctly reads signature, and shows something with programming. But several errors happen:
1. If requested to erase pages only used by hex file, reports "Invalid value or command sent" message and fails. So only looks like working with "Erase All Flash" option
2. "Display memory" does not work. After showing the dialog, first, it replaces "?" symbols with some data, but in 1-2 seconds either hangs up, or report AV in RICHED20.dll

Finally, still cannot make the program blinking LED, so unsure if programmed data is ok.

Pages: [1]