Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - FrankWu

#1
Dear Sir:

How to recover it to be unckeck in ISP operation? or anyother way?
What's the meaning of "NXP ICP BRIGDE" in interface option?

Best Regards,
Frank
#2
Hello:

I want to use DTR and RTS to control power on, how to Assert DTR and RTS using command line interface without any UART activities on TX and RX.

Best Regards,
Frank
#3
Hello:

I use the circuit the same as Keil MCB950 board. When I use oscilloscope to probe RXD of CP2102 after running flashmagic Read Device Signature. There is on "U" character timing on this pin. I have made sure the com port in cotrol panel an checking the com setup in flashmagic ok. Any possible problems could be?

Best Regards,
Frank