Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Ingo

Pages: [1]
1
Old Topics / rx2iap.lib
« on: September 22, 2004, 05:30:29 am »
Hi
Can I use this lib on 89c664?

/Ingo

2
Old Topics / 669iaplib
« on: July 08, 2004, 08:35:57 am »
Hi
I want to use the 669iaplib, but not as HUGE ROM model.
Is there anything else to change, or just ERET to RET?

3
Old Topics / See what happens on RS232
« on: June 26, 2003, 04:13:18 am »
If you need to see what FlashMagic do on our RS232 port,
Use this tool.

http://www.sysinternals.com/ntw2k/freeware/portmon.shtml

/Ingo

4
Old Topics / 89c664
« on: June 11, 2003, 07:33:25 am »
Hi

My problem is that i only have a 4 wire RS232 connection.
Rxd, Txd, GND and RTS.

I try'ed to use DTR and RTS to control RST and PSEN
In my case RTS to control PSEN.
FlashMagic send a 'U' to set up the Baudrate.
My software detect that 'U' echo back 'U.* and then let the "HARDWARE WATCHDOG TIMER (ONE-TIME ENABLED WITH RESET-OUT FOR P89C660/662/664)" make a  reset for me.
This works not so good, about 1 of 5.

At what point will FlashMagic send 'U'. Before RTS or under RTS or after RTS?

So i tried "STARTBOOTROM" insteed, and it works.
But FlashMagic activates RTS when it programming my device, so when it try to restart my software "PSEN" is low and the device will go into "ISP mode" again.

Is this a BUG or is there a way to keep RTS inactive when running STARTBOOTROM?

I want to have both option aviable

5
Old Topics / reprogram 89c664 with Flash Magic
« on: May 27, 2003, 04:58:23 am »
Hello

I have some problem to reprogram 89c664 with Flash Magic.

Only using RxD and Txd in the communication.
To set the Micro in ISP mode I wait for

Pages: [1]