Dear Friend,
Can we program the device, P89C51RD2BN from, 'org 0', if not then why...plz help.
Sudip Chatterjee
Can we program the device, P89C51RD2BN from, 'org 0', if not then why...plz help.
Sudip Chatterjee
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
P89C51Rx+/P89C51Rx2/P89C66x/P89C6xX2/P89V66x / programming P89C51RD2BN
March 08, 2004, 04:31:15 AM #2
Old Topics / problems in erasing P89C51RD2BN
March 04, 2004, 09:16:17 AM
Dear Friend....
I'm erasing the mcu for the first time...but when i attempt doing so, The 'FlashMagic' hangs, though it is connected at 9600 baud rate and the status bar reads 'erasing block 0'...i waited for above 5 minutes for the message 'finished erasing device' message, or something like that but in vain. I closed the software and had to reconnect the mcu only after hardware reset. When it read the flash memory bloch it showed all 00h...please help
I'm erasing the mcu for the first time...but when i attempt doing so, The 'FlashMagic' hangs, though it is connected at 9600 baud rate and the status bar reads 'erasing block 0'...i waited for above 5 minutes for the message 'finished erasing device' message, or something like that but in vain. I closed the software and had to reconnect the mcu only after hardware reset. When it read the flash memory bloch it showed all 00h...please help
Pages1