Hi !
Tried your tool with LPC4337 and starter board from starterkit. Added several hardware modifications for the board, as UART0 pins are partially used with Ethernet, so needed to move boot to UART3. FlashMagic detects the controller, correctly reads signature, and shows something with programming. But several errors happen:
1. If requested to erase pages only used by hex file, reports "Invalid value or command sent" message and fails. So only looks like working with "Erase All Flash" option
2. "Display memory" does not work. After showing the dialog, first, it replaces "?" symbols with some data, but in 1-2 seconds either hangs up, or report AV in RICHED20.dll
Finally, still cannot make the program blinking LED, so unsure if programmed data is ok.
Tried your tool with LPC4337 and starter board from starterkit. Added several hardware modifications for the board, as UART0 pins are partially used with Ethernet, so needed to move boot to UART3. FlashMagic detects the controller, correctly reads signature, and shows something with programming. But several errors happen:
1. If requested to erase pages only used by hex file, reports "Invalid value or command sent" message and fails. So only looks like working with "Erase All Flash" option
2. "Display memory" does not work. After showing the dialog, first, it replaces "?" symbols with some data, but in 1-2 seconds either hangs up, or report AV in RICHED20.dll
Finally, still cannot make the program blinking LED, so unsure if programmed data is ok.