Flash Magic returns always ExitCode 0 when calling it from command line.
In case of success or failure of programming a device the ExitCode is 0.
This is what I see when using FlashMagic version 1.65.
This can be verified by examining variable %errorlevel% after FM command:
I am using Flash Magic as follows in a .bat file (on one line):
FM COM(1, 57600) DEVICE(89C664, 10.000) ERASE(0,PROTECTISP) ERASE(1,PROTECTISP) ERASE(2,PROTECTISP) ERASE(3,PROTECTISP) ERASE(4,PROTECTISP) HEXFILE(%TARGETFILE%, NOCHECKSUMS, FILL, PROTECTISP)
ECHO %errorlevel%
Flash Magic is in our application a part of a lot of actions that are executed in a .bat file.
There is no feedback if programming of a device is successful or not.
It would be nice when Flash Magic does not successfully programs a device, an ExitCode not equal to 0 is returned. Our .bat file can then jump to a special error condition.
Can an ExitCode for Errors be added?
In case of success or failure of programming a device the ExitCode is 0.
This is what I see when using FlashMagic version 1.65.
This can be verified by examining variable %errorlevel% after FM command:
I am using Flash Magic as follows in a .bat file (on one line):
FM COM(1, 57600) DEVICE(89C664, 10.000) ERASE(0,PROTECTISP) ERASE(1,PROTECTISP) ERASE(2,PROTECTISP) ERASE(3,PROTECTISP) ERASE(4,PROTECTISP) HEXFILE(%TARGETFILE%, NOCHECKSUMS, FILL, PROTECTISP)
ECHO %errorlevel%
Flash Magic is in our application a part of a lot of actions that are executed in a .bat file.
There is no feedback if programming of a device is successful or not.
It would be nice when Flash Magic does not successfully programs a device, an ExitCode not equal to 0 is returned. Our .bat file can then jump to a special error condition.
Can an ExitCode for Errors be added?