Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - yuvaraj

#1
Hi
 

When click the start icon.

That time it is giving

Unable to connect specified baud rate, Try to reduce baud rate , Reset hardware to ISP mode again.

But i was used  least baud rate  2400, i reseted  the hardware so many times then also  it is giving same error,

Please guide to solve this problem



Thanks

R.Yuvaraj
#2
Hi

how do we load the boot files to p89v51rd2fn.


I downloaded boot files from some websites.

It is in .asm file format.

So how can  i update the boot files to P89v51rd2fn using  flashmagic


Advance thanks for your helping


Yuvaraj.R



#3
 Hi

   I am doing project based on Philips P89v51RD2FN.

i did the 5 steps procedure to dump the Hex code into  Device.

But i am getting error ,whem i am clicking the step 5----statr.

It is showing

Unable to connect at the specified baud rate. Try reducing the baud rate.Reset the hardware into ISP mode again

i had done the following steps in  Flash magic

Step 1:
com port --- com 1
Baud rate  ---- 2400
Device ---- 89V51RD2
Interface ---- ISP(none)
it disabled the oscillator frequency
Step 2:
I had marked erase bolcks used by Hex file

Step 3:
I had loaded my Hex file
Step 4:
I had marked verify after programming, set security bit 1,Gen block Checkgums

Finally i clicked start button. that timeit is giving the above mentioned errors




Please help me to avoid the error and dump program to device


Plz.....Plz help me