Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - tuxilein

#1
ok thats right is all the same but the pc has changeed for 1,5 year but for a month i can programm with this.

yes i have now 12 devices that i can't programm again it was all new devices.

you have no idea what can change but the funny think is i can programm a new device one time and than is out to programm it.
#2
mm i think you don't understand it.

my programmer circuit is ok and works good bevor. i use it over 2 years long now and i have net hed any problem with the programmer and reprogramming the mcu.

this problemm is now here. i can programm new mcu and the next time i didn't can programm it. noting change on the programmer hardware and no changes on the FM sw!

The circuit is from:
http://www.esacademy.com/software/flashmagic/appnotes/ISPHardwareEntryAppNote.pdf
site 5 and it works great. ok.

now you think after this the entry mode isn't ok?

thanks
#3
"Use DTR and RTS to enter ISP mode"  if you mean this, i did'nt change everything.

now i have connnect a lcd display on the i2c bus and if it will programm secound time any data trash came.
this is only on some mcu's.

i can programm every mcu one time the next time i't don't will programm it.

thanks



Post Edited (09-20-06 13:45)
#4
Hey,

i use Flash Magic Programmer a long time ago. I have had no problem with reprogramming the Device. Now i start to programm a device and it is done but i will reporgramm the same device nothing go.
I have not change any values it is all the same as before.

Flash magic can not conect after programing to the device. But the device is running.

Thanks