Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - nirbhay

#1
P89V51Rx2/P89LV51Rx2 / No Subject
April 23, 2006, 08:23:42 AM
hi

plz reply ot above msg. its urgent.

thanx.

nirbhay



Post Edited (04-23-06 08:26)
#2
HI

i m using p89v51rd2fn with 12mhz crystal,max 232 for serial progrmming.
i m not able to enter in isp mode. i hav cheked the intgrity of serial line,its fine.

i knw that after reset the 'U' character must be sent to uC to enter in ISP. and flash magic do the same thing.
 
i want to knw details of software and hardware methods to enter in ISP MODE.

wat shld be the status of EA/ , PSEN for entering ISP MODE??
shld  EA/ PIN  pulled high on rest for entering in ISP mode??

plz reply.


NIRBHAY



Post Edited (04-23-06 08:24)
#3

Hi  Jan,
 
   Thanx for reply. Problem is solved. There was a problem with serial line as u suggested.  
   
   Thanx  once again.

 Regards,
 Nirbhay

#4
P89V51Rx2/P89LV51Rx2 / progamming prob with P89V51RD2FN
January 28, 2006, 07:08:21 AM
Hi there,

         i m using SBC with P89V51RD2FN , MAX 232,RS 232 CABLE, 12 MHz crystal
i want to program P89V51RD2FN with flash magic in isp mode.

         i m using lateset flash magic version 2.47 (DLL version 1.95). but my problem is whenever i try to communicate thru serial cable i get the error msg saying that  " Reset the device in ISP mode now " with cancal button.

       i have read previous msgs of ur forum for same problem. so i have tried  
          1. resetting the ckt many times when i got error msg.
          2. switch on & off the power supply.
 
   but still i have the same problem the chip is new one. Is there any other solution? or should i have to depend upon parallel programmer?

       Plz help me. Wating for reply.

       Nirbhay.