Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jman777

#1
Old Topics / Re: Command Line programming for P89LPC935
February 20, 2004, 07:23:12 AM
There is a discrepancy when we use the Windows version and the Command Line version. We are using the Keil MCB 900 programming circuitry and there is a box that is checked in the Windows Flash Magic program "Options->Advanced Options->Hardware Config->"Use DTR and RTS to enter ISP mode".

The Windows Flash Magic program pulls DTR & RTS "high" then "low" then "high" to put the chip into ISP mode. When using the Command Line interface, the DTR & RTS lines do not do this.

How is this option enabled in the Command Line interface?

Thanks
#2
Old Topics / Command Line programming for P89LPC935
February 19, 2004, 04:00:45 PM
Please give a detailed description of EVERY step that the Windows Flash Magic program performs when a chip is programmed. What would be the exact same Command Line instructions?

Thanks!