Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mahalinr

Pages: [1]
I am having Flash Magic 7.30 Version.

I am able to compile my Master code in Flash Magic without any problem and in the Termainal I am getting the proper output.

But in my slave mode I have a problem in the Flash Magic Terminal,where nothing is displayed on the terminal screen.

Basically I want to communicate messages between Master to Slave.


I am currently using two LPC11C24 Microcontrollers in which one is Master and other is Slave Microcontroller. Now I need to send a message through CAN Protocol form one microcontroller to another microcontroller using IAR Workbench and through FLASH MAGIC .

I kindly need your help

thanks in advance

Pages: [1]