Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mrsam41

#1
Quote from: Amrita_lv on April 24, 2014, 12:17:23 PM
I have bought 15 nxp89v51rd2; i am using flash magic (version 7.72) to program it; out of 15 mc only 5 mc got programmed; for rest of the micro controller i am getting the issue; It shows reset the device into isp mode now, then if I press reset, nothing happens. So I thought it as a bootloader problem and I downloaded the bootloader from your site and programmed the micro-controller using TOP Universal programmer; After that I put it back on target board and tried to re-program it, now again it shows "reset the device to isp mode now" and i press reset, it works and goes to "erasing device......" after that nothing happens, it can not erase the device.
So I thought it as a configuration bit issue and used the TOP universal programmer to read the config bit for good microcontroller and non-working microcontroller; I found the working micro controller has following configuration "0x60=22 and 0x61=42"; but the non-working micro controller shows "0x60=0f and 0x61=02".
I need your help to solve the issue

Do you find out solution for this problem? if can pls help me how to fix? thank you.
#2
P89V51Rx2/P89LV51Rx2 / Re: Can't program p89v51RD2FA...AC
December 20, 2016, 01:28:47 AM
hi guy,
I have same problem with you. I have been using the P89V51RB2FA with PHILIPS logo on chip and i can program it very good. But now i buy some new P89V51RD2FA with NXP logo on chip ending with A0 and i can't program it. When i click Start a popup appear with message "Reset the device in to ISP mode now" and i press reset button on circuit boad then nothing happens, the popups still there and status information bar view "Attempting to connect..." untill i press Cancel. I used same circuit board and configuration Flash Magic software which i use with the 89V51RB2FA. Anyone can help me with this problem? Sorry about my basic English.