Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shiue

Pages: [1]
1
LPC9xx/LPC9xxx / Re: Is ISP hex file opened for lpc922 ?
« on: December 31, 2004, 07:13:29 pm »
Hi,Hitesh

You can reference http://www.hilosystems.com/.

2
LPC9xx/LPC9xxx / Re: Is ISP hex file opened for lpc922 ?
« on: December 04, 2004, 12:57:58 am »
I use ALL-P3 programmer to program ISP into 922 chip.
ALL-P3 programmer support this function.

ISP programs are not the same between lpc932 and lpc922.

3
General / Re: Flash Magic using USB
« on: December 04, 2004, 12:52:12 am »
I also have successfully used an Prolific chip(PL-2303)  USB to RS232  cable with Flash Magic.



Post Edited (12-04-04 01:53)

4
LPC9xx/LPC9xxx / Is ISP hex file opened for lpc922 ?
« on: November 23, 2004, 09:49:34 pm »
I am not care to erase lpc922.
So, I want to use parallel programmer to reprogram.
Where is  ISP hex file for lpc922.
Are they the same between lpc932 and lpc922 ?

5
Old Topics / Re: ISP to ICP bridge code
« on: November 23, 2004, 09:33:04 pm »
I don't know where is version 1.3 source file.
Andy say, version 1.3  source file is not opened.

I suggest that you can disassemble the version 1.3 hex file.
And, reference version 1.2 source file, reconstruct the version 1.3 source file.
It's a good idea.



Post Edited (11-23-04 22:35)

6
Old Topics / Re: FlashMagic and USB Converter
« on: November 12, 2004, 09:18:44 pm »
Usually, When you use a USB-Serial Cable.
Baud Rate can't speed up too high.
So , You can try 9600bps, change T1 & T2 for adaptively, High speed communications.

7
Old Topics / Re: Problem in PAB90x
« on: November 12, 2004, 08:48:29 pm »
I have email AN10258_2.pdf to you.

8
Old Topics / Re: ISP to ICP bridge code
« on: November 12, 2004, 08:36:05 pm »

9
General / Re: Flash Magic using USB
« on: November 12, 2004, 08:24:20 pm »
I have successfully used an FTDI chip(FT232AM/BM) USB  to RS232 cable with Flash Magic.



Post Edited (12-04-04 01:52)

10
Old Topics / Re: What's T1 and T2 for LPC9xx ISP hardware entry ?
« on: June 08, 2004, 10:44:02 pm »
Thanks Andy.

But, I mean that Why add t1 and t2 ?
What relation does the t1 & t2 have with the ISP?

Pages: [1]