Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - vrushali

#1
ARM Cortex / Re: NHS3100 flashing Failed
September 28, 2018, 03:15:42 AM
Hi Andy,
I am facing problem in flashing another board. i have attached flash magic tool snapshot. Its giving message as "Operation Failed.Failed to connect. Try disconnecting and reconnecting the board.Make sure the board appear in the device manager. also debug file is attached.
What is wrong?
#2
ARM Cortex / Re: NHS3100 flashing- Failed to Autobaud
September 21, 2018, 11:11:08 PM
Hi Andy,
I am following same procedure as mentioned by you.(LED status is also same)
About screenshot- I have one more board which is working. I took the screenshot of that.

Battery is not inserted while flashing.

Can you tell me about these 2 points in detail?
1) Could be due to static damage : Do you mean NHS3100 IC is damaged?
2) Could be due to configuring the part to disable SWD. : How can i check this?

Thanks for the help.
#3
ARM Cortex / Re: NHS3100 flashing- Failed to Autobaud
September 21, 2018, 12:06:04 AM
Hi Andy,

My Jumper settings on LPC link2: JP1 is open, JP2 is mounted.
i am using J7 connector on LPC link2 board to connect to target board.
Settings in flash magic:see flash magic setting.png in attachments.
flashmagic version 10.90

Thanks.
#4
ARM Cortex / NHS3100 flashing- Failed to Autobaud
September 20, 2018, 01:13:00 AM
Hello,
I am flashing NHS3100 (in Therapy adherence ADK) using Flash magic. But it is giving pop-up error as "Operation Failed. Failed to autobaud". LED on LPC link2 is blinking.
I have attached flash magic debug file in attachment.
#5
ARM Cortex / NHS3100 flashing- Failed to Autobaud
September 17, 2018, 02:18:00 AM
Hi,
I am using LPC link2 debug board for flashing NHS3100 using Flash magic.
It was working fine till now, but suddenly my LPC device is not getting detected when flash magic is open.
Before opening Flash magic, LED1 on lpc link2 board is ON continuously and lpc device is detected in device manager.
But after opening Flash magic system can not detect LPC device and LED1 is blinking continuously.

Anyone can help in finding what is basically the problem with my LPC-link 2 and how I can fix it.