Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LPC2148

Pages: [1]
1
LPC2xxx / it's about to send program to LPC2148
« on: April 21, 2020, 05:32:25 am »
Hi all,

I will start to use lpc-h2148 arm board.I have it. I wrote program.
I have a few question which I don't know.
I don't have jtag module
I have paralel and serial port on my pc

question 1) I want to upload program to arm board, Could I upload program via USB port on the arm board? ( I did not try it)

question 2) Could I upload program with USB to TTL  only by using TX,RX,GND?
There are 5 pin on the USB to TTL (+5V,TXD,RXD,GND,+3V)

baund rate 9600
I tried like this flashmagic program, but failed (program gave this error code  operation failed. Failed to autobaund)

USB to TTL >>>> LPC2148
TX         >>>> P0.1 RX
RX         >>>> P0.0 TX
GND        >>>> GND

I need your answer and ideas
with best regards,

Pages: [1]