Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - muhyin

#1
LPC9xx/LPC9xxx / ICP programming error
November 08, 2010, 04:41:24 AM
Dear All,

i'm working on LPC913 and got a problem to read the device signature of my LPC913.
i got all FF, i have checked pin configuration and the pins are connected as mentioned in application note document.
when i look into RESET pin, there is no burst 7x high-low signal.

has anyone experienced with it, could somebody help me. thanks

I have followed the instruction of "In Circuit Programming (ICP) Specifications" and "AN10258 Rev. 02 — 21 October 2004" documents.
is it problem with supply or what?


best regards
muhyin