Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Nabistay

#1
ARM Cortex / LPC1769 from Command Line
February 23, 2011, 11:09:46 AM
Hello. I am attempting to program an LPC1769 using flash magic and the USB-ISP-LPC2k.

It works perfectly through the GUI, but through the command line, i receive the error:

ERROR: Invalid parameters for DEVICE directive: DEVICE(LPC1769,25.0000000)

this command was directly from the "Save Command Line Directives" right after a successful programming of the device through the GUI.

These are the commands from the GUI:

COM(3, 230400)
DEVICE(LPC1769, 25.000000)
INTERFACE(FDIUSBICPLPC2K)
HARDWARE(BOOTEXEC, 300, 300)
ERASEUSED(E:\Dropbox\Senior Thesis - Group\PCB Software\Test\test.hex, PROTECTISP)
HEXFILE(E:\Dropbox\Senior Thesis - Group\PCB Software\Test\test.hex, NOCHECKSUMS, NOFILL, PROTECTISP)


This is the error:


C:\Program Files (x86)\Flash Magic>FM.EXE COM(3, 230400) DEVICE(LPC1769, 25.0000
00) INTERFACE(FDIUSBICPLPC2K) HARDWARE(BOOTEXEC, 300, 300) ERASEUSED(E:\Dropbox\
Senior Thesis - Group\PCB Software\Test\test.hex, PROTECTISP) HEXFILE(E:\Dropbox
\Senior Thesis - Group\PCB Software\Test\test.hex, NOCHECKSUMS, NOFILL, PROTECTI
SP)
Flash Magic Version 5.80.2216
8051/XA Driver Version 2.78.2196
ARM UART Driver Version 2.18.2198
ARM Cortex UART Driver Version 1.45.2208
ARM Ethernet Driver Version 1.09.2196
ARM CAN Driver Version 1.09.2198
(C) Embedded Systems Academy 2000-2011 All rights reserved
NON PRODUCTION USE ONLY

ERROR: Invalid parameters for DEVICE directive: DEVICE(LPC1769,
25.000000)