Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Rainer

#1
Hello,

I have tried to set the target device (LPC2106) into ISP mode with the STARTBOOTLOADER command (program version of FM.EXE is 7.51.3222). In my case it is a simple '!' 
So I tried  FM STARTBOOTLOADER(9600, %21, NOCONTROL) in the command line. But nothing happened - the FM-Tool isn't sending anything to target device (I monitor the serial traffic with a COM sniffer tool).
I also tried to specify the COM port and the Device:
FM COM(2, 9600) DEVICE(LPC2106, 14.7456, 0) STARTBOOTLOADER(9600, %21, NOCONTROL)
The same result -> no reaction on the COM Signal to the target device. Also there was no error message in both cases.

If I try to enter the ISP with a terminal program (HTerm) or even the "Start Bootloader"-Option in the GUI of Flash Magic it works fine.

Other command lines instructions are also working fine. e.g.: it was no problem to flash a hexfile with following instruction
FM COM(2, 9600) DEVICE(LPC2106, 14.7456, 0) ERASE(DEVICE, PROTECTISP) HEXFILE(Button.hex, CHECKSUMS, NOFILL, PROTECTISP)

During my experiments with the STARTBOOTLOADER command I tried the '&'-commands which are mentioned in the manual. Especially the &00 command (flush RX buffer). But none of the '&' command seem to work. I always get the error message, that the command 00 is unknown.

Are there some known issues with the STARTBOOTLOADER command or am I just using the wrong parameters?

Best regards

Rainer