Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - shashanksworld

#1
hello  every one...
I am using a 8051 programming board.Which has a rs232 b/w the controller and the db9 connector.
I had used 89v51rd2bn earlier on this board. with flash magic and programmed it through a serial port.

now I have upgraded my pc.but dont have a serial port ,so have bought a serial2 usb conector.
and I  want to flash 89v51rd2fn(could not find 89v51rd2bn in the market) with the same board.
as i am using a usb2serial converter it gets connected to COM3 port (as shown in device manager).
following are the flash magic setting i have used:
COMport-COM1
Baud Rate 9600
device :89v51rd2
interface :nonce(isp)
unckeched DTR &RTS while com port is open
checked erase bolcks used by hex file.
I am attaching the debug file
please check.
while debugging i have read the device signature:
error msg with com1 selected:unable to connect to device,try reducing the baud rate.
error msg with com3 selected:unable to connect,(configure )ensure no  other application is using com port ,try raising or lowering the baud rate.