P89LPC932 RevC Hangup

[Dan Goslicki]

HI-

Part is P89LPC932 Rev C. I am using the break detect method of entering the ISP code in my application. The 932 is running at 12MHz. I can parallel program a part, install it on the board, and run it o.k. When I try to re-program with Flash Magic, I send the break, Flash magic then indicates "Connected at 19200" in the window header,  gives the message "Erasing block 0.." at the bottom, then gets stuck (with the windows hourglass showing) forever. I have tried lowering the baud rate all the way down to 2400 with the same result. I can cycle power on the board, and the app (not updated) runs fine. Suggestions??

Thank you,
Dan

[Andy Ayre]

Please complete the "Last Resort" steps in the application note on the Flash Magic web page that describes what to do when ISP does not work. Thanks.